rock-crusher Nes>>com_news>>Sand in the operating procedures when operating what

Crusher Plant
About Rock Crusher PF Series Rock Crusher is a new product that absorbs advanced technologies at home and abroad.This Series equipment can crusher material which max...
More
HOW TO WORK PF Series Rock Crusher use impact energy to crush materials. When the Rock Crusher works, the motor drives the rotor rotate of the Rock Crusher with high speed.
More
Successful Case

Sand in the operating procedures when operating what

Rock Crusher car checked before tune eddy chamber observed the door is closed to prevent the material from the eddy chamber observe the door out of danger . Check the impeller rotation direction from the direction of the feed inlet . The impeller should rotate counterclockwise , otherwise it should be adjusted to the motor wiring . Sand and conveying equipment startup sequence : the nesting → Rock Crusher→ feeder breakers must load starting direction to be the crusher is operating normally feed . Sand stop order is contrary to the boot sequence .

Feed particles strictly follow the regulations to prohibit greater than the specified materials into the crusher , otherwise, would be too much wear and tear caused by the imbalance of the impeller and impeller , with the base to cause clogging the impeller channel and center feed tube , so that the crusher not working properly found over the chunk into the material should be immediately removed . The nesting device stopped moving in time to stop feeding , otherwise, will result in crushed impeller, and burnt motor .

Strive to feed the continuous and uniform . Broken in the process of machine operation , without the intense vibration and abnormal noise , otherwise, stop and check . The lubrication of the machine . Mobil car lubrication oil lubrication for dry , premium greases , dosage is 1/2-2/3 of the bearing cavity , each the work of the crusher intervals , add the right amount of grease , working after a number of classes open the main bearings to clean the main bearing , if necessary, replace the bearing .
Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail:yifanec@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64966831 Fax: +86-371-64628872

Article by Rock Crusher,Rock Crushers Yifan Machinery edit : http://www.rock-crusher.org , For reproduced please indicate the source , little things , thank you .

Crusher Plant Case
Contact Us
  • Tel:+86-371-64966831
  • Fax:+86-371-64628872
  • E-mail:yifanseo@yfmac.com
  • Msn:yifancrusher@yahoo.cn
Copyrigh©2009,Yifan Rock Crusher.
Address:Zhengyuan Rd,Xingyang,ZhengZhou Henan 450100,China.
Welcome to the the YIFAN mechanical rock crusher machinery net
--wumi